Results for: TPS2814D in Gate and Power Driver
Send an RFQ for this part NOW  »

Select the line item to get a quote for part number TPS2814D or refine your search within part number {1} part variation at the bottom of this page.
If you're not already a Broker Forum member, get your free access to contact TPS2814D vendors.

Gate and Power Driver

A gate driver is a power amplifier that accepts a low-power input from a controller IC and produces a high-current drive input for the gate of a high-power transistor such as an IGBT or power MOSFET. Gate drivers can be provided either on-chip or as a discrete module. In essence, a gate driver consists of a level shifter in combination with an amplifier. In contrast to bipolar transistors, MOSFETs do not require constant power input, as long as they are not being switched on or off. The isolated gate-electrode of the MOSFET forms a capacitor (gate capacitor), which must be charged or discharged each time the MOSFET is switched on or off. As a transistor requires a particular gate voltage in order to switch on, the gate capacitor must be charged to at least the required gate voltage for the transistor to be switched on. Similarly, to switch the transistor off, this charge must be dissipated, i.e. the gate capacitor must be discharged. When a transistor is switched on or off, it does not immediately switch from a non-conducting to a conducting state; and may transiently support both a high voltage and conduct a high current. Consequently, when gate current is applied to a transistor to cause it to switch, a certain amount of heat is generated which can, in some cases, be enough to destroy the transistor. Therefore, it is necessary to keep the switching time as short as possible, so as to minimize switching loss. Typical switching times are in the range of microseconds. The switching time of a transistor is inversely proportional to the amount of current used to charge the gate. Therefore, switching currents are often required in the range of several hundred milliamperes, or even in the range of amperes. For typical gate voltages of approximately 10-15V, several watts of power may be required to drive the switch.

Power Management > Drivers > Gate and Power Driver

Part No.	DS	Manufacturer	D/C	Qty	Region	Action
TPS2814DR		TI	-	7026	China	Request A Quote
TPS2814DR		TI	2017+	2487	China	Request A Quote
TPS2814DR		TI	2014+	398	Japan	Request A Quote
TPS2814DR		TI	202104+	12000	China	Request A Quote
TPS2814DR		TI	2009+	42	China	Request A Quote
TPS2814DR		TI	2019+	4799	China	Request A Quote
TPS2814DR		TI	2011+	2124	Japan	Request A Quote
TPS2814DR		TI	-	4565	Hong Kong	Request A Quote
TPS2814DR		TI	-	12000	China	Request A Quote
TPS2814DR		TI	-	23955	China	Request A Quote
TPS2814DR		TI	2011+	748	South Korea	Request A Quote
TPS2814DR		TI	2017+	2487	Singapore	Request A Quote
TPS2814DR		TI	2020+	2500	Singapore	Request A Quote
TPS2814DR		TI	201022	711	Germany	Request A Quote
TPS2814DR		TI	-	12533	China	Request A Quote
TPS2814DR		TI	-	35524	Hong Kong	Request A Quote
TPS2814DR		TI	2011+	748	U.S.A.	Request A Quote
TPS2814DR		TI	2009	3432	U.S.A.	Request A Quote
TPS2814DR		TI	2022+	10000	China	Request A Quote
TPS2814DR		TI	-	23955	Hong Kong	Request A Quote
TPS2814DR		TI	2021+	19945	China	Request A Quote
TPS2814DR		TI	-	2500	Germany	Request A Quote
TPS2814DR		TI	201138+	27	China	Request A Quote
TPS2814DR		TI	201036+	3000	China	Request A Quote
TPS2814DR		TI	-	19269	China	Request A Quote

1 2 Next

Send an RFQ for part number TPS2814D   »