Results for: 6N139 in Photovoltaic Output PhotoCouplers
Send an RFQ for this part NOW  »

Select the line item to get a quote for part number 6N139 or refine your search within part number {1} part variation at the bottom of this page.
If you're not already a Broker Forum member, get your free access to contact 6N139 vendors.

Results 1-13 for 6N139 (of 13)
Advanced Search Show

Photovoltaic Output PhotoCouplers

Photovoltaics (PV) is a method of converting solar energy into direct current electricity using semiconducting materials that exhibit the photovoltaic effect. A photovoltaic system employs solar panels composed of a number of solar cells to supply usable solar power. Power generation from solar PV has long been seen as a clean sustainable energy technology which draws upon the planet’s most plentiful and widely distributed renewable energy source – the sun. The direct conversion of sunlight to electricity occurs without any moving parts or environmental emissions during operation. It is well proven, as photovoltaic systems have now been used for fifty years in specialized applications, and grid-connected PV systems have been in use for over twenty years. They were first mass produced in the year 2000, when German environmentalists including Eurosolar succeeded in obtaining government support for the 100,000 roofs program. In electronics, an opto-isolator, also called an optocoupler, photocoupler, or optical isolator, is a component that transfers electrical signals between two isolated circuits by using light. Opto-isolators prevent high voltages from affecting the system receiving the signal. Commercially available opto-isolators withstand input-to-output voltages up to 10 kV and voltage transients with speeds up to 10 kV/μs. A common type of opto-isolator consists of an LED and a phototransistor in the same opaque package. Other types of source-sensor combinations include LED-photodiode, LED-LASCR, and lamp-photoresistor pairs. Usually opto-isolators transfer digital (on-off) signals, but some techniques allow them to be used with analog signals.

Advertisement